November 24, 2024

The way to Set up Recessed Ceiling Box Lighting

Tools

Six recessed can lights, two 3/4-inch birch plywood sheets, every 4’x8′, paint (you should use Ace Sensations Ceiling White), skim coat, two ladders, tape measure, utility knife, reciprocal noticed, blue chalk, chalk line, stud finder, pencil, sander, degree, round noticed, table noticed, wooden glue, hammer and nails.

Steps

You need to first choose a location the place you need to put the recessed boxes proper on the ceiling. You possibly can then use a chalk or marker to mark a line on the ceiling. The measurement you should use is about 118 inches, coming 36-1/2″ from the wall that’s mendacity parallel from the road you draw light box B08FD52RR6.

It’s best to then just remember to make an inspection gap through the use of a hammer. This inspection gap is used to observe {the electrical} wires within the ceiling. When doing this, you’ll then measure the part on the ceiling, after which use the hammer to chop out a bit inside the measured half. After that, use the reciprocal noticed to chop out the opening, and use the rafters as a information. It’s best to have one other individual within the attic to observe you as you chop; you need to keep away from the opportunity of slicing the electrical cables and pipes by mistake. The rafters that you simply lower and take away will be saved for future use elsewhere in the home.

Place a body on the ends of the 2 rafters. The centre plate is the one that can maintain the load. The drywall ought to then be eliminated so as so that you can full the tough opening. This course of ought to then even be executed on the second beam.

A hammer can then be used, in some circumstances, to eliminate the cross beams, if this appears essential to you. A double header will be positioned proper on the ends of the drywall in order to care for the load that was supported by the beams which have been eliminated. An skilled electrician ought to then be introduced in to put in the cables for the brand new areas of the box.

Take the birch plywood and make measurements on it in order to suit for the boxes; the sizes of the plywood can then be lower with the usage of a table noticed. Make measurements and mark the sports activities the place the lights will probably be put in within the new boxes. Use a slicing machine to chop out the holes for the lights, a most of three holes in every box will do. Place the can lights proper above the boxes. The boxes will probably be fitted contained in the rafters of the ceiling.

You’ll then use nails and glue within the assembling of the ceiling boxes. Place the brand new boxes inside the opening of the tough wall. The within edges on the boxes ought to then be smoothed with sandpaper, making a round sample in order to eliminate any nicks within the wooden. The ending touches can then be introduced out by portray each the ceiling and the boxes.

Properly, that is it; when the paint has dried fully, you possibly can then match the lights contained in the recessed light boxes, and change them on – you are executed.